SLIDING ROOF SYSTEM > TERMINALS OF ECU |
| CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) |
Disconnect the R23 ECU connector.

Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| R23-1 (B) - R23-2 (E) | R - W-B | +B Power supply | Power switch off | 11 to 14 V |
| R23-5 (IG) - R23-2 (E) | B - W-B | Power switch power supply | Power switch off | Below 1 V |
| R23-5 (IG) - R23-2 (E) | B - W-B | Power switch power supply | Power switch on (IG) | 11 to 14 V |
| R23-2 (E) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the R23 ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Wiring Color | Terminal Description | Condition | Specified Condition |
| R23-7 (OPN) - R23-2 (E) | SB - W-B | Sliding roof motor open | Power switch on (IG), OPEN switch on | Below 1 V |
| R23-7 (OPN) - R23-2 (E) | SB - W-B | Sliding roof motor open | Power switch on (IG), OPEN switch off | 11 to 14 V |
| R23-9 (CLS) - R23-2 (E) | BR - W-B | Sliding roof motor close | Power switch on (IG), CLOSE switch on | Below 1 V |
| R23-9 (CLS) - R23-2 (E) | BR - W-B | Sliding roof motor close | Power switch on (IG), CLOSE switch off | 11 to 14 V |