Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM

PRE-COLLISION SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC
  1. Connect the Techstream to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Pre-Collision / Trouble Codes.

  5. Enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes.

  6. Check the details of the DTC(s) (Click here).

HINT:
As the driving support ECU and seat belt control ECU output DTCs for the pre-collision system, be sure to check the Pre-Collision and Pre-Collision 2 DTCs.


CLEAR DTC
  1. Connect the Techstream to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Pre-Collision / Trouble Codes.

  5. Enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes.

  6. Clear the DTCs.

HINT:
As the driving support ECU and seat belt control ECU output DTCs for the pre-collision system, be sure to clear the Pre-Collision and Pre-Collision 2 DTCs.