Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HV RELAY ASSEMBLY

HV RELAY ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL HYBRID BATTERY JUNCTION BLOCK

CAUTION:
Be sure to wear insulated gloves.



    A215059
  1. Install the hybrid battery junction block with the 3 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



    A215058
  1. Connect the 2 connectors to the hybrid battery junction block.

    NOTICE:
    The connectors should be connected securely.



    A215057
  1. Connect the 2 connectors to the hybrid battery junction block.



2. CONNECT FRAME WIRE

CAUTION:
Wear insulating gloves.



    A215051
  1. Install the frame wire on the hybrid battery junction block assembly with the 2 nuts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. Make sure that the ends of the frame wire are not crossed over each other.
    2. Be sure to connect the frame wires to the correct terminals.

  1. Connect the clamp and frame wire.



3. CHECK HIGH VOLTAGE CABLE CONNECTION

CAUTION:
Wear insulated gloves and protective goggles.



  1. Check that each wire harness is being installed securely.


    A237807E01


    Text in Illustration 
    *3
    Frame Wire
    -
    -

    NOTICE:
    1. Make sure that the end of the frame wire are not crossover each other.
    2. Be sure to connect the frame wire to the correct terminals as shown in the illustration.
    3. The connectors should be connected securely.
    4. The nuts should be fastened securely.
    5. Make sure that the 4 plastic covers are engaged securely.



4. INSTALL UPPER HYBRID BATTERY COVER SUB-ASSEMBLY

HINT:
Click here.