Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Transmission Control ECU Communication Stop Mode

for Preparation Click here


DESCRIPTION

The transmission control ECU drives the parking lock actuator in accordance with signals from the power management control ECU.

Detection Item
Symptom
Trouble Area
Transmission Control ECU Communication Stop Mode
  1. "Transmission Control " is not displayed on "CAN Bus Check" screen of the Techstream.
  2. Applies to Transmission Control Communication Stop Mode in DTC Combination Table.
  1. Transmission control ECU branch wire or connector
  2. Power source circuit of transmission control ECU
  3. Transmission control ECU

WIRING DIAGRAM


C210478E01


INSPECTION PROCEDURE

NOTICE:
  1. Turn the power switch off before measuring the resistances between CAN bus main wires and between CAN bus branch wires.
  2. Turn the power switch off before inspecting CAN bus wires for a ground short.
  3. After the power switch is turned off, check that the key reminder warning system and light reminder warning system are not operating.
  4. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the power switch, any other switches or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
  1. Operating the power switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
  2. Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.

1.CHECK CAN BUS WIRE FOR DISCONNECTION (TRANSMISSION CONTROL ECU BRANCH WIRE)
  1. Turn the power switch off.



    C210476E01
  1. Disconnect the transmission control ECU connector.
    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Transmission Control ECU)

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A24-16 (CA1H) - A24-15 (CA1L)
    Power switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN BUS MAIN WIRE OR CONNECTOR (ECM MAIN WIRE)
OK


2.CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL)


    C210477E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A23-16 (+B) - Body ground
    Power switch on (IG)
    11 to 14 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Transmission Control ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK


3.CHECK HARNESS AND CONNECTOR (GROUND TERMINAL)


    C210476E02
  1. Disconnect the transmission control ECU connector.
    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Transmission Control ECU)

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A24-1 (E1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT)
OK

REPLACE TRANSMISSION CONTROL ECU (Click here)