Home › Suspension › REAR SUSPENSION › REAR COIL SPRING

REAR COIL SPRING > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEELS


2. DISCONNECT REAR SPEED SENSOR WIRE (for LH Side)


    C208053
  1. Using a screwdriver, disconnect the connector from the rear speed sensor.

    NOTICE:
    Be careful not to damage the rear speed sensor.



3. DISCONNECT REAR SPEED SENSOR WIRE (for RH Side)

HINT:
Perform the same procedure as the LH side.



4. SEPARATE REAR SPEED SENSOR WIRE (for LH Side)


    C207255
  1. Remove the nut and separate the 2 clamps and rear speed sensor wire.



5. SEPARATE REAR SPEED SENSOR WIRE (for RH Side)

HINT:
Perform the same procedure as the LH side.



6. SEPARATE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH (w/ Height Control Sensor)


    C207241
  1. Remove the bolt and separate the rear height control sensor sub-assembly RH from the rear axle beam assembly.



    C207242E01
  1. Using a vinyl tape, secure the rear height control sensor sub-assembly RH as shown in the illustration.
    Text in Illustration 
    *1
    Vinyl Tape



7. SEPARATE REAR WHEEL HOUSE LINER LH (w/ Wheel House Liner)


    C207233
  1. Remove the clip and turn back the rear wheel house liner LH to separate the rear wheel house liner LH.



8. SEPARATE REAR WHEEL HOUSE LINER RH (w/ Wheel House Liner)

HINT:
Perform the same procedure as the LH side.



9. REMOVE REAR COIL SPRING LH


    C207243E01
  1. Loosen the 2 bolts.
    Text in Illustration 
    *1
    LH Side
    *2
    RH Side

    NOTICE:
    Do not remove the bolts.



  1. Support the spring seat of the rear axle beam assembly using 2 jacks and 2 wooden blocks.


    C207239E01


    Text in Illustration 
    *1
    Jack
    *2
    Wooden Block

    CAUTION:
    Do not jack up the rear axle beam assembly too high as the vehicle may fall.

    HINT:
    Support the rear shock absorber at a position where it compresses by approximately 20 to 30 mm (0.787 to 1.18 in.).

  1. Remove the 2 bolts while holding the 2 nuts and separate the rear axle beam assembly from the rear shock absorber assemblies LH and RH.

    NOTICE:
    Since the stopper nuts are used, turn the bolts.



    C207244
  1. Slowly lower the rear axle beam assembly using 2 jacks and 2 wooden blocks, and remove the rear coil spring LH.

    NOTICE:
    When moving the rear axle beam assembly beyond full rebound, make sure that the rear axle beam assembly is not out of position for more than 10 minutes.



  1. Slowly jack up the rear axle beam assembly using 2 jacks and 2 wooden blocks, and temporarily tighten the rear axle beam assembly to the rear shock absorber assemblies LH and RH with the 2 bolts and 2 nuts.


    C207240E01


    Text in Illustration 
    *1
    Jack
    *2
    Wooden Block

    NOTICE:
    Since the stopper nuts are used, turn the bolts.



10. REMOVE REAR COIL SPRING RH

HINT:
Perform the same procedure as the LH side.



11. REMOVE REAR UPPER COIL SPRING INSULATOR LH


12. REMOVE REAR UPPER COIL SPRING INSULATOR RH


13. REMOVE REAR LOWER COIL SPRING INSULATOR LH


14. REMOVE REAR LOWER COIL SPRING INSULATOR RH