HOOD > ADJUSTMENT |

| *1 | Centering Bolt |
| *2 | Standard Bolt |
| 1. INSPECT HOOD SUB-ASSEMBLY |
Check that the clearance measurements of areas *1 through *4 are within each standard range.

| Area | Measurement | Area | Measurement |
| *1 | 2.0 to 6.0 mm (0.0787 to 0.236 in.) | *2 | 2.0 to 6.0 mm (0.0787 to 0.236 in.) |
| *3 | 2.5 to 5.5 mm (0.0984 to 0.217 in.) | *4 | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) |
| 2. ADJUST HOOD SUB-ASSEMBLY |
Horizontally and vertically adjust the hood.
![]() |
Loosen the 4 hinge bolts of the hood.
Adjust the clearance between the hood and front fender by moving the hood.
Tighten the 4 hinge bolts after the adjustment.
Adjust the height of the front end of the hood using the cushion rubbers.
![]() |
Adjust the 2 cushion rubbers so that the heights of the hood and fender are aligned.
Adjust the hood lock.
![]() |
Loosen the 3 bolts.
Tighten the bolts after the adjustment.
Check that the striker can engage with the hood lock smoothly.