TIRE PRESSURE WARNING SYSTEM > SYSTEM DESCRIPTION |
| DESCRIPTION OF SYSTEM |
A tire pressure warning valve and transmitter is equipped with a tire pressure sensor and a transmitter and is installed in each tire and wheel assembly. The sensor measures the tire pressure. The measured value and transmitter ID are transmitted to the tire pressure warning antenna and receiver on the body as radio waves and then sent to the tire pressure warning ECU from the tire pressure warning antenna and receiver. If the transmitter ID has already been registered, the ECU compares the measured air pressure value with the standard value. When the value is less than the standard value registered in the tire pressure warning ECU, the warning light on the combination meter comes on. The tire pressure warning reset switch addresses the differences in the air pressure settings by the type of tires.

| INITIAL CHECK |
![]() |
After the power switch is turned to on (IG), the tire pressure warning light comes on for 3 seconds and then go off.
| WHEN TIRE PRESSURE WARNING LIGHT IS LIT |
When the tire pressure warning light does not go off, or when it comes on during driving, check the tire pressure. If the tire pressure warning light comes on within several hours of adjusting the tire pressure, the tire may have a slow air leak.
Under the following conditions, the system may not function properly:
The system will be disabled in the following conditions:
(When the condition becomes normal, the system will work properly.)
The system may be disabled in the following conditions:
(When the condition becomes normal, the system will work properly.)
After removing and installing the ECU or a sensor, check for a diagnostic trouble code and verify that it is a normal system code.
| FUNCTION OF COMPONENTS |
| Components | Function |
| Tire pressure warning valve and transmitter | Combined as a single unit with a disc wheel air valve, it measures tire pressure and temperature and transmits an ID number for measurement value and identification. Built-in the battery. |
| Tire pressure warning antenna and receiver | Receives and transmits a necessary signal from the transmitters to the tire pressure warning ECU. |
| Tire pressure warning ECU | Receives a signal from the receiver and identifies it as vehicle's own signal. If the measured value is equal to or lower than the specified value, it transmits a signal to illuminate the tire pressure warning light on the combination meter. |
| Tire pressure warning light | Located in the combination meter, it informs the driver of lowered tire pressure and system failure. |
| Tire pressure warning reset switch | Allows entering initialization mode for when the standard pressure is changed |
| TIRE PRESSURE WARNING RESET SWITCH |