Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

DTC    P0C30-390    Hybrid Battery Pack State of Charge High

for Preparation Click here


DESCRIPTION

The Power management control ECU monitors its internal operation, it will set DTCs and perform fail-safe control when it detects the following malfunctions.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0C30
390
Charge control error
Charging of the HV battery continues even after charging is prohibited when the hybrid system is malfunctioning and "State of Charge (All Bat)" has reached the upper limit.
(1 trip detection logic)
Power management control ECU

Related Data List 
DTC No.
Data List
P0C30-390
  1. State of Charge (All Bat)
  2. Charge Control Value
  3. Power Resource IB
  4. Battery too High Time

INSPECTION PROCEDURE

HINT:
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
  1. When the vehicle is stopped with the power switch on (READY) and drive (D) selected, depress the accelerator pedal. The engine rpm will increase as well as "State of Charge (All Bat)".
    If charge current drops, release the accelerator pedal and then depress it again to maintain charging.
  2. Check that charging stops when "State of Charge (All Bat)" reaches the upper limit.

1.CHECK DTC OUTPUT (HV)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    P0C30-390 only is output.
    A
    DTCs other than P0C30-390 are output.
    B

  1. Turn the power switch off.



B
GO TO DTC CHART (Click here)
A

REPLACE POWER MANAGEMENT CONTROL ECU (Click here)