Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A2B-250    Drive Motor "A" Temperature Sensor Circuit Range / Performance

DTC    P0A2E-248    Drive Motor "A" Temperature Sensor Circuit Intermittent

for Preparation Click here


DESCRIPTION

The resistance of the thermistor built into the motor temperature sensor changes in accordance with changes in motor (MG2) temperature. The lower the motor (MG2) temperature, the higher the thermistor resistance. Conversely, the higher the temperature, the lower the resistance.

HINT:
The term "drive motor A" indicates motor (MG2).


A172965E04


DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A2B
250
Motor temperature sensor output does not increase under conditions in which the value should increase, or output does not decrease under conditions in which the value should decrease.
(1 trip detection logic)
Hybrid vehicle motor assembly (Motor temperature sensor)
P0A2E
248
Sudden change in motor temperature sensor output or hunting
Unusual sudden change in motor temperature sensor output occurs and offset condition continues for a certain period of time, or unusual change in motor temperature sensor output occurs repeatedly.
(1 trip detection logic)

Related Data List 
DTC No.
Data List
P0A2B-250
Motor Temp No1
P0A2E-248

INSPECTION PROCEDURE

HINT:
  1. If DTC P0A2B-250 is output, clear the DTCs, perform the following procedure, and check that the same DTC is not output after the repair.
    1. Drive the vehicle (stop and go driving) on urban roads for approximately 5 minutes.
      If the Data List item "Motor Temp No1" shows both increases and decreases in temperature, suspected areas indicated by this DTC are not malfunctioning.
  2. If DTC P0A2E-248 is output, clear the DTCs, perform the following procedure, and check that the same DTC is not output after the repair.
    1. Turn the power switch on (READY) and wait for 30 seconds or more.
    2. Drive the vehicle for approximately 5 minutes according to the freeze frame data items "Vehicle Spd", "Motor Temp No1" and "Motor Temp No2".

1.REPLACE HYBRID VEHICLE MOTOR ASSEMBLY
  1. Replace the hybrid vehicle motor assembly (Click here).

HINT:
The motor temperature sensor is not available separately. If it requires replacement, replace the hybrid vehicle motor assembly.


NEXT

COMPLETED