Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY

HOOD LOCK CONTROL CABLE ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY


  1. Pass the hood lock control cable assembly into the engine compartment.


    B227889E01


    Text in Illustration 
    *1
    Hood Lock Control Cable
    *2
    Grommet
    *3
    Hood Cable Grommet
    -
    -

  1. Pass the cable through the upper radiator support.

  1. Engage each clamp shown in the illustration.



    B227885
  1. Connect the hood lock control cable assembly.



2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B227891
  1. Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
  1. Connect each connector.

  1. Engage the clamp.

  1. Engage the 2 guides and claw to connect the hood lock control cable.



    B298864
  1. Engage the 6 claws and clip.

  1. Install the lower instrument panel finish panel assembly with the screw <C>.



4. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH


    B227764
  1. Engage the 2 clips.

  1. Install the cowl side trim board LH with the clip.



5. INSTALL FRONT DOOR SCUFF PLATE LH


    B227761
  1. Engage the 10 claws to install the front door scuff plate LH.



6. INSTALL FRONT FENDER LINER LH

HINT:
Use the same procedure for the RH side and LH side .



7. INSTALL FRONT WHEEL LH

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }