Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY

HOOD LOCK CONTROL CABLE ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL LH


2. REMOVE FRONT FENDER LINER LH

HINT:
Use the same procedure for the RH side and LH side .



3. REMOVE FRONT DOOR SCUFF PLATE LH


    B227761
  1. Disengage the 10 claws and remove the front door scuff plate LH.



4. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH


    B227764
  1. Remove the clip.

  1. Disengage the 2 clips and remove the cowl side trim sub-assembly LH.



5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY


    B298862
  1. Remove the screw <C>.



    B298863
  1. Disengage the 6 claws and clip as shown in the illustration.



    B223463
  1. Disengage the claw and 2 guides and disconnect the hood lock control cable.

  1. Disconnect each connector and clamp, and remove the lower instrument panel finish panel assembly.



6. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B227891
  1. Disconnect the hood lock control cable assembly from the hood lock control lever sub-assembly.



7. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY


    B227885
  1. Disconnect the hood lock control cable assembly.



  1. Using a screwdriver, disengage each clamp shown in the illustration.


    B227889E01


    Text in Illustration 
    *1
    Hood Lock Control Cable
    *2
    Grommet
    *3
    Hood Cable Grommet
    -
    -

    HINT:
    Tape the screwdriver tip before use.

  1. Pull the hood lock control cable assembly from the engine compartment and remove it.