Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A94-589    DC / DC Converter Performance

DTC    P0A94-590    DC / DC Converter Performance

for Preparation Click here


DESCRIPTION

The MG ECU uses a voltage sensor that is built into the boost converter to detect pre-boost high voltage (VL) to allow boost control. The MG ECU monitors the boost converter voltage sensor signal line and detects the following malfunctions.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A94
589
Boost converter voltage (VL) signal is stuck (Low)
(1 trip detection logic)
Inverter with converter assembly
P0A94
590
Boost converter voltage (VL) signal is stuck (High)
(1 trip detection logic)

Related Data List 
DTC No.
Data List
P0A94-589
VL-Voltage before Boosting
P0A94-590

MONITOR DESCRIPTION

The MG ECU monitors the boost converter voltage (VL) sensor circuit. If the MG ECU detects an open or short circuit malfunction of the VL sensor circuit, the power management control ECU (HV CPU) will illuminate the MIL and set a DTC.

MONITOR STRATEGY


Related DTCs
P0A94 (INF 589): VL malfunction (Disconnection and GND short)
P0A94 (INF 590): VL malfunction (+B short)
Required sensors / components
Boost converter
Frequency of operation
Continuous
Duration
TMC's intellectual property
MIL operation
1 driving cycle
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
TMC's intellectual property
Other conditions belong to TMC's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


TMC's intellectual property
-

COMPONENT OPERATING RANGE


Power management control ECU (HV CPU)
DTC P0A94 (INF 589/590) is not detected

CONFIRMATION DRIVING PATTERN


A218446E22

  1. Connect the Techstream to the DLC3.
  2. Turn the power switch on (IG) and turn the Techstream on.
  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  4. Turn the power switch off and wait for 30 seconds or more.
  5. Turn the power switch on (IG) and after 5 seconds, turn the power switch off. [A]
  6. Repeat [A] 3 times. [B]
  7. Turn the power switch on (IG) and turn the Techstream on.
  8. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes. [C]
  9. Read the current DTCs.

    HINT:
    1. If a current DTC is output, the system is malfunctioning.
    2. If a current DTC is not output and want to confirm permanent DTC, perform the following procedure.

  10. Check that permanent DTCs are cleared.
  11. If the permanent DTCs are not cleared, perform the universal trip, and then check for permanent DTCs again.

INSPECTION PROCEDURE

HINT:
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
  1. Turn the power switch on (IG) and wait for 5 seconds or more.

1.REPLACE INVERTER WITH CONVERTER ASSEMBLY

HINT:
The boost converter voltage (VL) sensor is connected to the MG ECU inside the inverter with converter assembly. If P0A94-589 or P0A94-590 is output, replace the inverter with converter assembly (Click here).


NEXT

END