SMART KEY SYSTEM (for Start Function) > DTC CHECK / CLEAR |
| CHECK DTC |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Power Source Control / Trouble Codes.
Read the DTC by following the prompts on the Techstream screen.
| CLEAR DTC |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Power Source Control / Trouble Codes.
Clear the DTC by following the directions on the Techstream screen.