Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SWITCH ASSEMBLY

SLIDING ROOF SWITCH ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT SLIDING ROOF SWITCH (MAP LIGHT ASSEMBLY)


    B226503E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    U13-2 (CLS) - U13-9 (GND1)
    CLOSE switch is pressed
    Below 1 Ω
    U13-2 (CLS) - U13-9 (GND1)
    CLOSE switch is not pressed
    10 kΩ or higher
    U13-16 (OPN) - U13-9 (GND1)
    OPEN switch is pressed
    Below 1 Ω
    U13-16 (OPN) - U13-9 (GND1)
    OPEN switch is not pressed
    10 kΩ or higher

    Text in Illustration 
    *1
    Component without harness connected
    (Sliding Roof Switch (Map Light Assembly))
    If the result is not as specified, replace the sliding roof switch (map light assembly).