Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Front Fog Light Circuit

for Preparation Click here


DESCRIPTION

The main body ECU (multiplex network body ECU) controls the front fog light relay.

WIRING DIAGRAM


E192997E05


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Main Body / Active Test.

  1. Check that the relay operates.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Front Fog Light Relay
    Front fog light relay
    ON/OFF
    -

    OK:
    Front fog light relay operates. (Front fog lights come on.)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK OPERATION (TAILLIGHTS)
  1. Check the operation of the taillights.

    OK:
    Taillights operate normally.



NG
GO TO PROBLEM SYMPTOMS TABLE (Click here)
OK


3.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


    E182509E04
  1. Remove the instrument panel junction block assembly.

  1. Connect a positive (+) lead from the battery to terminal 2E-1.

  1. Connect a negative (-) lead from the battery to terminals A-14 and A-13.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    2C-8 - Battery negative
    Always
    11 to 14 V

    Text in Illustration 
    *1
    Component without harness connected
    (Instrument Panel Junction Block Assembly)



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
OK


4.CHECK HARNESS AND CONNECTOR (BULB - INSTRUMENT PANEL JUNCTION BLOCK AND BODY GROUND)
  1. Disconnect the 2C instrument panel junction block assembly connector.

  1. Disconnect the C4 or C6 fog light assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C4-2 - 2C-8
    Always
    Below 1 Ω
    C6-2 - 2C-8
    Always
    Below 1 Ω
    2C-8 - Body ground
    Always
    10 kΩ or higher
    C4-1 - Body ground
    Always
    Below 1 Ω
    C6-1 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)