Home › Engine / Hybrid System › CRUISE CONTROL › DRIVING SUPPORT ECU

DRIVING SUPPORT ECU > REMOVAL

for Preparation Click here



1. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


    B237541E01
  1. Disengage the claw and release the glove compartment door stopper.
    Text in Illustration 
    *1
    Glove Compartment Door Stopper Sub-assembly
    *2
    Moulding Remover
    *3
    Lower Instrument Panel Sub-assembly
    *4
    Glove Compartment Door Assembly
    *5
    Stopper

  1. Insert the moulding remover into the location shown in the illustration.

  1. Move the moulding remover in the direction indicated by the arrow to bend the lower instrument panel sub-assembly and release the stopper (A).

    HINT:
    Use the same procedure to release the stopper (B).



    B223649E01
  1. Open the glove compartment door assembly to approximately 55° from its closed position. Pull it horizontally in the direction indicated by the arrow to disengage the 2 hinges and remove the glove compartment door assembly.
    Text in Illustration 
    *a
    Close
    *b
    Open Approximately

    NOTICE:
    Pulling the glove compartment door assembly upward to remove it causes the hinges to deform. Be sure to pull out the glove compartment door assembly horizontally.



2. REMOVE DRIVING SUPPORT ECU


    E186386
  1. Disconnect the connector.



    E186385
  1. Remove the nut and driving support ECU.