Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM

SEAT BELT WARNING SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the Techstream to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / SRS Airbag, Occupant Detection or Combination Meter / Data List.

  5. Read the Data List according to the display on the Techstream.

    SRS Airbag (Center Airbag Sensor Assembly) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Left side Buckle SW
    Driver side seat belt buckle switch/Unset, Set or NG
    Unset: Driver side seat belt unfastened
    Set: Driver side seat belt fastened
    NG: Data not determined
    -
    Right side Buckle SW
    Front passenger side seat belt buckle switch/Unset, Set or NG
    Unset: Front passenger side seat belt unfastened
    Set: Front passenger side seat belt fastened
    NG: Data not determined
    -

    Occupant Detection (Occupant Classification ECU) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Passenger Buckle SW
    Front passenger side seat belt buckle switch/Unset, Set or NG
    Unset: Front passenger side seat belt unfastened
    Set: Front passenger side seat belt fastened
    NG: Data not determined
    -

    Combination Meter (Combination Meter Assembly) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Driver Side Seatbelt Warning Buzzer
    Driver side seat belt warning buzzer/ON or OFF
    Customized value displayed
    -
    P-Seatbelt Warning Buzzer
    Front passenger side seat belt warning buzzer/ON or OFF
    Customized value displayed
    -


ACTIVE TEST
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
  1. Connect the Techstream to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  5. Perform the Active Test according to the display on the Techstream.

    Combination Meter (Combination Meter Assembly) 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Driver Side Seat Belt
    Driver side seat belt warning light
    OFF or ON
    Confirm that the vehicle stopped with the engine idling.
    Front Passenger Side Seat Belt
    Front passenger side seat belt warning light
    OFF or ON
    Confirm that the vehicle stopped with the engine idling.