Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Entire Combination Meter does not Operate

for Preparation Click here


DESCRIPTION

This circuit is the power source circuit for the meter. This circuit provides two types of power sources; one is a constant power source, and the other is an IG power source. If a voltage of 12 V is not applied to terminal IG+ when the power switch is turned on (IG), the indicators will not operate.

WIRING DIAGRAM


E143732E40


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY CIRCUIT)


    E160303E48
  1. Disconnect the L27 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L27-30 (ES) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    L27-19 (IG+) - Body ground
    Power switch off
    Below 1 V
    L27-19 (IG+) - Body ground
    Power switch on (IG)
    11 to 14 V
    L27-18 (B) - Body ground
    Power switch off
    11 to 14 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Combination Meter Assembly (No. 3 Meter Circuit Plate))



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (NO. 3 METER CIRCUIT PLATE) (Click here)