Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM

REAR VIEW MONITOR SYSTEM > SYSTEM DESCRIPTION

for Preparation Click here



GENERAL
  1. To assist the driver with parking the vehicle by displaying an image of the area behind the vehicle, this system has a rear television camera assembly mounted on the back door. The system displays the image on the navigation ECU sub-assembly*1 or radio and display receiver assembly*2.

  2. The rear view monitor system consists of the following components:

    1. Navigation ECU sub-assembly*1

    2. Radio and display receiver assembly*2

    3. Rear television camera assembly

    4. No. 1 integration relay

    5. Power management control ECU

      1. *1: for Navigation Receiver Type or for Radio and Display Type (w/o Daytime Running Light)
      2. *2: for Radio and Display Type (w/ Daytime Running Light)


FUNCTION OF COMPONENTS
  1. The navigation ECU sub-assembly*1 or radio and display receiver assembly*2 controls the system by using information from the following components:

    Item
    Function
    Rear Television Camera Assembly
    1. Mounted on the back door to transmit an image of the area behind the vehicle to the navigation ECU sub-assembly*1 or radio and display receiver assembly*2.
    2. Has a color video camera that uses a Charge Coupled Device (CCD) and a wide-angle lens.
    Navigation ECU Sub-assembly*1
    Radio and Display Receiver Assembly*2
    1. Receives video signals, which contain an image of the area behind the vehicle taken with the rear television camera assembly.
    2. Performs control of the system by receiving the reverse signal from the No. 1 integration relay.
    3. Displays the rear view monitor image on the display panel.
    No. 1 Integration Relay
    Transmits a reverse signal to the navigation ECU sub-assembly*1 or radio and display receiver assembly*2.
    Power Management Control ECU
    Transmits a reverse signal to the No. 1 integration relay.

    1. *1: for Navigation Receiver Type or for Radio and Display Type (w/o Daytime Running Light)
    2. *2: for Radio and Display Type (w/ Daytime Running Light)


OPERATION EXPLANATION
  1. The navigation ECU sub-assembly*1 or radio and display receiver assembly*2 receives the reverse signal from the No. 1 integration relay when the power switch is on (READY) and the shift lever is moved to R. After receiving the reverse signal, the navigation ECU sub-assembly*1 or radio and display receiver assembly*2 switches from the navigation system to the rear view monitor system.

    1. *1: for Navigation Receiver Type or for Radio and Display Type (w/o Daytime Running Light)
    2. *2: for Radio and Display Type (w/ Daytime Running Light)