Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM

DTC    P3000-603    Battery Control System

for Preparation Click here


DESCRIPTION

The power management control ECU monitors its internal operation and detects the following malfunction.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P3000
603
The HV battery temperature becomes too high due to a malfunction in the HV system.
(1 trip detection logic)
  1. Power management control ECU
  2. HV battery

Related Data List 
DTC No.
Data List
P3000-603
  1. Temp of Batt TB1 to TB3
  2. Inhaling Air Temp
  3. Ambient Temperature
  4. Power Resource IB
  5. State of Charge (All Bat)
  6. Cooling Fan Mode1
  7. Cooling Fan 0
  8. Hot Temperature Time
The following items can be helpful when performing repairs:
Data List
  1. Vehicle Spd
  2. Engine Run Time
  3. Ready Signal

INSPECTION PROCEDURE

HINT:
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
  1. Drive the vehicle for approximately 10 minutes according to the freeze frame data items "Vehicle Spd", "Temp of Batt TB1 to TB3", "Inhaling Air Temp", "Ambient Temperature" and "Power Resource IB".

1.CHECK DTC OUTPUT (HV)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    P3000-603 only is output.
    A
    DTCs other than P3000-603 are also output.
    B

  1. Turn the power switch off.



B
GO TO DTC CHART (Click here)
A


2.REPLACE POWER MANAGEMENT CONTROL ECU
  1. Replace the power management control ECU (Click here).


NEXT

REPLACE HV BATTERY (Click here)