Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM

AIRBAG SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.
DTCs are displayed by blinking of the SRS warning light.

HINT:
  1. When each warning light stays blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.
  2. A DTC output mode signal is transmitted through the CAN communication system to each ECU including the center airbag sensor assembly. Thus when all systems do not enter DTC output mode, there may be an power management control ECU malfunction.


WIRING DIAGRAM


C165791E03


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (TC OF DLC3 - TC OF POWER MANAGEMENT CONTROL ECU)
C226004E03
  1. Turn the power switch off.

  1. Disconnect the connector from the power management control ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L61-13 (TC) - L5-11 (TC)
    Always
    Below 1 Ω

    Text in Illustration 
    *1
    DLC3
    *2
    Front view of wire harness connector
    (to Power Management Control ECU)



NG
REPLACE WIRE HARNESS
OK


2.CHECK WIRE HARNESS (CG OF DLC3 - BODY GROUND)


    C204945E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L61-4 (CG) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *1
    DLC3



NG
REPLACE WIRE HARNESS
OK


3.CHECK WIRE HARNESS (TC OF DLC3 - BODY GROUND)


    C204945E06
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L61-13 (TC) - Body ground
    Always
    1 MΩ or higher

    Text in Illustration 
    *1
    DLC3



NG
REPLACE WIRE HARNESS OR EACH ECU
OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)