Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type)

NAVIGATION SYSTEM (for Radio and Display Type) > The Other Caller cannot Hear Your Voice, or Your Voice is too Quiet or Distorted

for Preparation Click here


INSPECTION PROCEDURE

HINT:
If an outlet of the air conditioning system is facing the microphone, noise may be recorded and the other caller may not be able to hear your voice properly.

1.CHECK CELLULAR PHONE
  1. Check if the other caller can hear your voice properly.

    OK:
    Your voice can be heard properly.

    HINT:
    The purpose of this step is to inspect the cellular phone when it is not connected to the vehicle.



NG
REPLACE CELLULAR PHONE
OK


2.CHECK SETTINGS
  1. Display the screen on the telephone.



    E227340E01
  1. Check that the "Mute Call" switch is not set to on.

    OK:
    "Mute Call" switch is not set to on.

    Text in Illustration 
    *a
    Example



NG
TURN "Mute Call" SWITCH OFF
OK


3.CHECK MICROPHONE LEVEL (OPERATION CHECK)


    E227337
  1. Enter the "Microphone Level Test" screen. Refer to Check Microphone Level in Operation Check (Click here).

  1. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

    OK:
    Check result is normal.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE EXTENSION MODULE (Click here)