Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM

TIRE AND WHEEL SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT TIRES
  1. Check the tires for wear and proper inflation pressure.

    Cold Tire Inflation Pressure:

    Tire Size
    Front
    kPa (kgf/cm2, psi)
    Rear
    kPa (kgf/cm2, psi)
    P195/65R15 89S
    240 (2.4, 35)
    230 (2.3, 33)
    P215/45R17 87V
    230 (2.3, 33)
    220 (2.2, 32)
    195/65R15 91H
    220 (2.2, 32)
    220 (2.2, 32)



    C137874
  1. Using a dial indicator, check the runout of the tires.

    Maximum Tire Runout:
    1.4 mm (0.0551 in.)



2. ROTATE TIRES
  1. Rotate the tires as shown in the illustration.

    Area
    Rotate Tire
    Vehicle Front Facing Left
    North America

    C199582

    Mexico

    C199586

    Korea
    C199584

    Torque:
    103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



3. INSPECT WHEEL BALANCE


    C144018E10
  1. Check and adjust the off-the-car balance.
    Text in Illustration 
    *a
    25 mm (0.984 in.)

    Maximum Imbalance After Adjustment:
    8.0 g (0.0176 lb)

    NOTICE:
    1. Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.
    2. Do not touch the adhesive surface of the tape.
    3. Adhere a sticking type balance weight to the flat surface*a shown in the illustration.
    4. Push the balance weight securely with your finger to adhere it to the position.
    5. Do not reuse the balance weight.

    HINT:
    The inner side balance weight should be installed by clipping it to the rim.



4. INSPECT FRONT AXLE HUB BEARING LOOSENESS
  1. Inspect the front axle hub bearing looseness (Click here).



5. INSPECT REAR AXLE HUB BEARING LOOSENESS
  1. Inspect the rear axle hub bearing looseness (Click here).



6. INSPECT FRONT AXLE HUB RUNOUT
  1. Inspect the front axle hub runout (Click here).



7. INSPECT REAR AXLE HUB RUNOUT
  1. Inspect the rear axle hub runout (Click here).