Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › ACCELERATOR PEDAL SENSOR

ACCELERATOR PEDAL SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL ACCELERATOR PEDAL ASSEMBLY

NOTICE:
  1. Avoid physical shock to the accelerator pedal assembly.
  2. Do not disassemble the accelerator pedal assembly.
  3. This accelerator pedal assembly does not require lubrication.
  4. Do not apply oil or other lubrication to the accelerator pedal assembly. If applied, the accelerator pedal assembly must be replaced.



    A220945
  1. Install the accelerator pedal assembly with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the accelerator pedal assembly connector.