DTC B15C2 Speed Signal Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B15C2 | A difference between the GPS speed and SPD pulse is detected. |
|

| 1.CHECK VEHICLE SENSOR (OPERATION CHECK) |
![]() |
Enter the "Vehicle Sensors" screen. Refer to Check GPS & Vehicle Sensors in Operation Check (Click here).
While driving the vehicle, compare the "Speed" indicator to the reading on the speedometer. Check if these readings are almost equal.
|
| ||||
| OK | ||
| ||
| 2.INSPECT NO. 3 METER CIRCUIT PLATE (OUTPUT WAVEFORM) |
![]() |
Check the output waveform.
Remove the No. 3 meter circuit plate with the connector(s) still connected.
Connect an oscilloscope to terminal L27-7 (+S) and body ground.
Turn the power switch on (IG).
Turn a wheel slowly.
Check the signal waveform according to the condition(s) in the table below.
| Item | Condition |
| Measurement terminal | L27-7 (+S) - Body ground |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Vehicle condition | Wheel being rotated |
| *a | Component with harness connected (No. 3 Meter Circuit Plate) |
|
| ||||
| OK | |
| 3.INSPECT NAVIGATION ECU SUB-ASSEMBLY (INPUT WAVEFORM) |
![]() |
Check the input waveform.
Remove the navigation ECU sub-assembly with the connector(s) still connected.
Connect an oscilloscope to terminal L130-17 (SPD) and body ground.
Turn the power switch on (IG).
Turn a wheel slowly.
Check the signal waveform according to the condition(s) in the table below.
| Item | Condition |
| Measurement terminal | L130-17 (SPD) - Body ground |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Vehicle condition | Wheel being rotated |
| *a | Component with harness connected (Navigation ECU Sub-assembly) |
|
| ||||
| OK | ||
| ||