Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (for Brush Type Motor)

POWER STEERING SYSTEM (for Brush Type Motor) > TERMINALS OF ECU

for Preparation Click here



CHECK POWER STEERING ECU

F044303E24


Text in Illustration 
*1
Component without harness connected
(Power Steering ECU)
  1. Measure the voltage and resistance according to the value(s) in the table below.

    NOTICE:
    1. Check if the power steering ECU connectors are securely connected by pulling on them from the backside.
    2. If the P/S warning light is illuminated due to a malfunction, the fail-safe function may cause the voltage of the power steering ECU's terminals to become 0 V.


    Terminals No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    A27-1 (PIG) - Body ground
    W - Body ground
    Power steering motor power supply input signal
    Always
    11 to 14 V
    A27-2 (PGND) - Body ground
    W-B - Body ground
    Power ground
    Always
    Below 1 Ω
    z12-1 (M1) - Body ground
    R - Body ground
    Power steering motor output signal 1
    Power switch on (READY), steering wheel turned to left
    11 to 14 V
    Power switch on (READY), steering wheel turned to right
    Below 1 V
    z12-2 (M2) - Body ground
    B - Body ground
    Power steering motor output signal 2
    Power switch on (READY), steering wheel turned to left
    Below 1 V
    Power switch on (READY), steering wheel turned to right
    11 to 14 V
    L54-1 (CANH) - L54-7 (CANL)
    R - W
    CAN communication line
    (CAN HI signal)
    Power switch off
    54 to 69 Ω
    L54-6 (IG) - Body ground
    B - Body ground
    IG power source
    Power switch on (IG)
    11 to 14 V
    L54-7 (CANL) - L54-1 (CANH)
    W - R
    CAN communication line
    (CAN LO signal)
    Power switch off
    54 to 69 Ω
    z13-5 (TRQ1) - Body ground
    W - Body ground
    Torque sensor 1 input signal
    Power switch on (READY), steering wheel not turned (without load)
    2.3 to 2.7 V
    Power switch on (READY), steering wheel turned to right
    2.5 to 3.8 V
    Power switch on (READY), steering wheel turned to left
    1.2 to 2.5 V
    z13-6 (TRQV) - Body ground
    R - Body ground
    Torque sensor power source
    Power switch on (READY)
    4.5 to 5.5 V
    z13-7 (TRQ2) - Body ground
    Y - Body ground
    Torque sensor 2 input signal
    Power switch on (READY), steering wheel not turned (without load)
    2.3 to 2.7 V
    Power switch on (READY), steering wheel turned to right
    1.2 to 2.5 V
    Power switch on (READY), steering wheel turned to left
    2.5 to 3.8 V
    z13-8 (TRQG) - Body ground
    B - Body ground
    Torque sensor ground
    Always
    Below 1 Ω
    If the result is not as specified, the ECU may have a malfunction.