Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (for Brush Type Motor)

POWER STEERING SYSTEM (for Brush Type Motor) > FAIL-SAFE CHART

for Preparation Click here


If a problem occurs in the power steering system, the P/S warning light will come on in the combination meter and the power steering assist will be stopped, locked at a particular point, or decreased simultaneously to protect the system.

DTC No.
DTC Detection Condition
Fail-safe
C1511
C1512
C1513
C1514
C1515
C1516
Torque sensor malfunction
Power assist stopped
C1517
Torque sensor malfunction
Power assist stopped
C1524
Motor malfunction
Power assist stopped
C1531
C1532
Power steering ECU malfunction
Power assist stopped
C1533
Temperature sensor malfunction in power steering ECU
Assist force restricted
C1534
EEPROM abnormal
Power assist stopped
C1535
Steering wheel location data error
Power assist stopped
C1551
IG power source voltage error
Power assist stopped
C1552
PIG power source voltage error
Power assist stopped
C1553
Overvoltage at IG and PIG terminals
Power assist stopped
C1554
Power source relay malfunction
Power assist stopped
C1555
Motor relay malfunction
Power assist stopped
C1581
ECU malfunction (Assist map number un-writing)
Permission of control assist map
C1582
Assist map number mismatch
Controlled using current default map
U0129
Skid control ECU communication error
Amount of power assist remains constant at speed of 70 km/h (43 mph)
U0293
HV ECU communication error
Power assist stopped
U1104
Driving support ECU communication error
Power assist control normally (Lane keeping assist system does not operate)

HINT:
  1. The amount of power assist may be decreased to prevent the motor and ECUs from overheating if the steering wheel is continuously turned when the vehicle is either stopped or driven at a low speed, or if the steering wheel is kept in either full lock position for a long time. In such cases, the amount of power assist returns to normal if the steering wheel is not turned for approximately 10 minutes with the power switch on (READY).
  2. If the auxiliary battery is not sufficiently charged or the voltage decreases temporarily, the amount of power assist will be reduced and the P/S warning light will come on. In such cases, the amount of power assist returns normal when the auxiliary battery voltage recovers.