Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › ECM

ECM > REMOVAL

for Preparation Click here



1. REMOVE REAR NO. 2 FLOOR BOARD (for Separate Type)


    B227787E01
  1. Disengage the 2 guides <A> as shown in the illustration.

  1. Disengage the 3 guides <B> and remove the rear No. 2 floor board.



2. REMOVE REAR DECK FLOOR BOX
  1. Remove the rear deck floor box.



3. REMOVE REAR NO. 3 FLOOR BOARD


    B227791
  1. Disengage the 2 guides and remove the rear No. 3 floor board.



4. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL


5. SEPARATE INVERTER RESERVE TANK ASSEMBLY


    A212304
  1. Remove the 2 bolts and separate the inverter reserve tank assembly.



6. REMOVE ECM
  1. Remove the No. 1 relay block cover.



    A212300
  1. Disconnect the 3 wire harness connectors.



    A212301
  1. Disengage the 2 claws, push up the engine room wire harness and separate it from the engine room relay block.



    A212302
  1. Disengage the 2 claws and push up the side cover to remove it.



    A212303
  1. Loosen the bolt and separate the No. 2 engine room wire.



  1. Disconnect the 2 ECM connectors.



      A212305
    1. Disconnect the 2 wire harness clamps.

    2. Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.

      NOTICE:
      After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.



    A212306
  1. Separate the 2 wire harness clamps.



    A212307
  1. Remove the 2 bolts and ECM with 2 ECM brackets.