Home › Engine / Hybrid System › 2ZR-FXE ENGINE CONTROL › THROTTLE BODY

THROTTLE BODY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT THROTTLE BODY ASSEMBLY
  1. Check for throttle control motor operating sound.

    1. Turn the power switch on (IG).

    2. When depressing the accelerator pedal, check the operating sound of the motor. Make sure that no friction noises are emitted from the motor. If any friction noise exists, replace the throttle body assembly.

  1. Set the vehicle to the inspection mode (Click here).

  1. Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range when the A/C is switched off.

    Standard:
    Condition
    Engine Idle Speed
    A/C switched off
    950 to 1050 rpm

    NOTICE:
    1. Be sure to perform this step with all accessories off.
    2. Make sure that park (P) is selected.