MASS AIR FLOW METER > ON-VEHICLE INSPECTION |
| 1. INSPECT MASS AIR FLOW METER |
Read the values using the Techstream (MAF).
Connect the Techstream to the DLC3.
Turn the power switch on (IG) (do not run the engine).
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List / MAF.
Wait 30 seconds, and read the values on the Techstream.
| Tester Display | Condition | Standard Condition |
| MAF |
| Less than 0.25 g/sec |