COOLING SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT FOR COOLANT LEAK (for Engine) |
Remove the reservoir tank cap.
![]() |
Fill the radiator and reservoir with coolant, and then attach a radiator cap tester.
Put the engine in inspection mode (Click here).
Warm up the engine.
Using the reservoir cap tester, increase the pressure inside the radiator to 108 kPa (1.1 kgf/cm2, 16 psi), and check that the pressure does not drop. If the pressure drops, check the hoses, radiator, front exhaust pipe assembly and the heater hose around and engine water pump for leaks. If no external leaks are found, check the heater core, cylinder block and cylinder head.
Remove the radiator cap tester.
Install the reservoir tank cap.
| 2. INSPECT RESERVOIR TANK ENGINE COOLANT LEVEL (for Engine) |
![]() |
Check that the engine coolant level is between the low and full lines when the engine is cold.
| *1 | Full line |
| *2 | Low line |
| 3. INSPECT ENGINE COOLANT QUALITY (for Engine) |
Remove the reservoir tank cap.
Check if there are any excessive deposits of rust or scales around the radiator cap and radiator filler hole. Also, the coolant should be free of oil.
If excessively dirty, clean the coolant passage and replace the coolant.
Install the reservoir tank cap.