FUEL INJECTOR > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
Discharge fuel system pressure (Click here).
| 2. REMOVE REAR NO. 2 FLOOR BOARD (for Separate Type) |
![]() |
Disengage the 2 guides <A> as shown in the illustration.
Disengage the 3 guides <B> and remove the rear No. 2 floor board.
| 3. REMOVE REAR DECK FLOOR BOX |
Remove the rear deck floor box.
| 4. REMOVE REAR NO. 3 FLOOR BOARD |
![]() |
Disengage the 2 guides and remove the rear No. 3 floor board.
| 5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 6. REMOVE EGR WITH COOLER PIPE SUB-ASSEMBLY |
| 7. DISCONNECT ENGINE WIRE |
![]() |
Disconnect the 4 fuel injector connectors.
Disconnect the 4 connectors.
Remove the bolt.
Detach the 2 clamps to disconnect the wire harness.
| 8. DISCONNECT FUEL TUBE SUB-ASSEMBLY |
![]() |
Release the claw and remove the No. 1 fuel pipe clamp.
![]() |
Pinch the tube connector, and then pull the tube connector off of the pipe.
| 9. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY |
![]() |
Remove the bolt.
![]() |
Remove the 2 bolts and the fuel delivery pipe sub-assembly.
| 10. REMOVE NO. 1 DELIVERY PIPE SPACER |
![]() |
Remove the 2 delivery pipe spacers from the cylinder head.
| 11. REMOVE FUEL INJECTOR ASSEMBLY |
![]() |
Pull the 4 fuel injector assemblies out of the fuel delivery pipe sub-assembly.
Remove the O-ring from each fuel injector.
![]() |
For reinstallation, attach a tag or label to each injector shaft.
![]() |
Remove the 4 injector vibration insulators.