AIR CONDITIONING UNIT > DISASSEMBLY |
| 1. REMOVE ID CODE BOX (IMMOBILISER CODE ECU) (w/ Engine Immobiliser System) |
![]() |
Remove the bolt and ID code box (immobiliser code ECU).
| 2. REMOVE BLOWER ASSEMBLY |
Remove the screw and disconnect the quick heater connector.
Disconnect the connector and disengage each clamp.
Disengage the 3 screws and guide, and remove the blower assembly.

| *1 | Quick Heater Connector | - | - |
| 3. REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY |
![]() |
Disengage the 2 claws and remove the No. 1 air duct sub-assembly.
| 4. REMOVE AIR CONDITIONING DUCT SUB-ASSEMBLY |
![]() |
Disengage the 2 claws and remove the air conditioning duct sub-assembly.
| 5. REMOVE AIR CONDITIONING HARNESS ASSEMBLY |
Disconnect each connector.
Disengage each clamp and remove the air conditioning harness assembly.

| 6. REMOVE AIR OUTLET CONTROL SERVO MOTOR SUB-ASSEMBLY |
![]() |
Remove the 3 screws and air outlet control servo motor sub-assembly.
| 7. REMOVE AIR MIX CONTROL SERVO MOTOR SUB-ASSEMBLY |
![]() |
Remove the 3 screws and air mix control servo motor sub-assembly.
| 8. REMOVE QUICK HEATER ASSEMBLY |
![]() |
Disengage each clamp.
Remove the 2 screws.
![]() |
Remove the quick heater assembly as shown in the illustration.
| 9. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY |
![]() |
Remove the screw and clamp.
| *1 | Clamp |
![]() |
Remove the heater radiator unit sub-assembly as shown in the illustration.
| 10. REMOVE CONSOLE MOUNTING BRACKET LH |
![]() |
Remove the screw and console mounting bracket LH.
| 11. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY |
![]() |
Remove the screw.
Disengage the 2 guides and remove the air conditioning amplifier assembly as shown in the illustration.
| 12. REMOVE CONSOLE MOUNTING BRACKET RH |
![]() |
Disengage the 2 claws and remove the console mounting bracket RH.
| 13. REMOVE DRAIN COOLER HOSE |
![]() |
Remove the drain cooler hose as shown in the illustration.
| 14. REMOVE COOLER EXPANSION VALVE |
![]() |
Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and cooler expansion valve.
| 15. REMOVE COOLER EVAPORATOR SUB-ASSEMBLY |
![]() |
Remove the packing.
![]() |
Remove the 4 screws.
Disengage the 4 claws and remove the lower heater case.
![]() |
Disengage the clamp and remove the cooler evaporator sub-assembly with the No. 1 cooler thermistor.
![]() |
Remove the 2 O-rings from the cooler evaporator sub-assembly.
| 16. REMOVE NO. 1 COOLER THERMISTOR |
![]() |
Remove the No. 1 cooler thermistor.