Home › Drivetrain › AXLE AND DIFFERENTIAL › STEERING KNUCKLE

STEERING KNUCKLE > INSTALLATION

for Preparation Click here



1. INSTALL STEERING KNUCKLE
  1. Secure the steering knuckle between aluminum plates in a vise.

    NOTICE:
    Do not overtighten the vise.



    C206993
  1. Install the front axle hub sub-assembly and front disc brake dust cover with the 4 bolts.

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }



    C207000E01
  1. Apply MP grease to the areas indicated by the arrows in the illustration on the front drive shaft assembly contact surface of the front axle hub sub-assembly.
    Text in Illustration 
    *1
    MP grease

    HINT:
    Apply 0.1 to 0.3 g (0.00353 to 0.0106 oz.) of MP grease to each area.



2. INSTALL FRONT LOWER BALL JOINT ASSEMBLY
  1. Secure the front axle assembly in a vise.

    NOTICE:
    When using a vise, do not overtighten it.



    C207005
  1. Install the front lower ball joint assembly to the front axle assembly with the nut.

    Torque:
    71 N*m{ 724 kgf*cm , 52 ft.*lbf }

  1. Install a new clip.

    NOTICE:
    Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.



3. INSTALL FRONT AXLE ASSEMBLY

HINT:
Refer to the procedures from Install Front Axle Assembly .