Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > Air Conditioning Control Panel Circuit

for Preparation Click here


DESCRIPTION

This circuit consists of the A/C control assembly and A/C amplifier. When the A/C control assembly is operated, signals are transmitted to the A/C amplifier through the LIN communication system.
If the LIN communication system malfunctions, the A/C amplifier does not operate even if the A/C control assembly is operated.

WIRING DIAGRAM


E180171E15


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (A/C CONTROL ASSEMBLY - BODY GROUND)
E167399E35
  1. Disconnect the A/C control assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L152-8 (GND) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to A/C Control Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (A/C CONTROL ASSEMBLY - BATTERY)


    E167399E36
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    L152-5 (IG+) - L152-8 (GND)
    Power switch on (IG)
    11 to 14 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to A/C Control Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER - A/C CONTROL ASSEMBLY)


    E177002E65
  1. Disconnect the A/C amplifier connector.



    E167399E37
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L17-37 (LIN1) - L152-2 (TX+)
    Always
    Below 1 Ω
    L17-37 (LIN1) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to A/C Amplifier)
    *2
    Front view of wire harness connector
    (to A/C Control Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE A/C CONTROL ASSEMBLY
  1. Replace the A/C control assembly with a known good one and check if the same problem occurs again (Click here).

    OK:
    Same problem does not occur.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (A/C CONTROL ASSEMBLY WAS DEFECTIVE)