Home › Vehicle Interior › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)


  1. Disconnect the 2B and 2C junction block connectors.


    B231709E13


    Text in Illustration 
    *A
    Main body ECU (multiplex network body ECU) with 3 connectors
    -
    -
    *1
    Main body ECU (multiplex network body ECU)
    *2
    3 connectors

    E192848E15


    Text in Illustration 
    *A
    Main body ECU (multiplex network body ECU) with 1 connector
    -
    -
    *1
    Main body ECU (multiplex network body ECU)
    *2
    1 connector

  2. Disconnect the A main body ECU connector.

  3. Measure the voltage and resistance according to the value(s) in the table below.

    HINT:
    Measure the values on the wire harness side with the connectors disconnected.


    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    2B-6 (GND1) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    2C-18 (BECU) - Body ground
    Y - Body ground
    Battery power supply
    Power switch off
    11 to 14 V
    A-29 (ACC) - Body ground
    -
    ACC power supply
    Power switch on (ACC)
    11 to 14 V
    A-29 (ACC) - Body ground
    -
    ACC power supply
    Power switch off
    Below 1 V
    A-31 (ALTB) - Body ground
    -
    Battery power supply
    Power switch off
    11 to 14 V
    A-32 (IG) - Body ground
    -
    Power switch power supply
    Power switch on (IG)
    11 to 14 V
    A-32 (IG) - Body ground
    -
    Power switch power supply
    Power switch off
    Below 1 V
    If the result is not as specified, there may be a malfunction in the wire harness.

  4. Reconnect the 2B and 2C junction block connectors.

  5. Reconnect the A main body ECU connector.

  6. Measure the voltage according to the value(s) in the table below.

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    2B-1 (ACT-) - Body ground
    B - Body ground
    Door lock motor unlock drive output (except driver side)
    Driver or front passenger side door control switch off
    Below 1 V
    2B-1 (ACT-) - Body ground
    B - Body ground
    Door lock motor unlock drive output (except driver side)
    Driver or front passenger side door control switch unlocked
    11 to 14 V
    2B-8 (ACT+) - Body ground
    L - Body ground
    Door lock motor lock drive output (all doors)
    Driver or front passenger side door control switch off
    Below 1 V
    2B-8 (ACT+) - Body ground
    L - Body ground
    Door lock motor lock drive output (all doors)
    Driver or front passenger side door control switch locked
    11 to 14 V
    2B-5 (ACTD) - Body ground
    B - Body ground
    Driver side door lock motor unlock drive output
    Driver or front passenger side door control switch off
    Below 1 V
    2B-5 (ACTD) - Body ground
    B - Body ground
    Driver side door lock motor unlock drive output
    Driver or front passenger side door control switch unlocked
    11 to 14 V
    2D-36 (FRCY) - Body ground
    BR - Body ground
    Front passenger side door courtesy switch input
    Front passenger side door open
    Below 1 V
    2D-36 (FRCY) - Body ground
    BR - Body ground
    Front passenger side door courtesy switch input
    Front passenger side door closed
    11 to 14 V
    2D-35 (FLCY) - Body ground
    V - Body ground
    Driver side door courtesy switch input
    Driver door open
    Below 1 V
    2D-35 (FLCY) - Body ground
    V - Body ground
    Driver side door courtesy switch input
    Driver door closed
    11 to 14 V
    2D-25 (LSR) - Body ground
    GR - Body ground
    Rear door LH lock position switch input
    Rear door LH unlocked
    Below 1 V
    2D-25 (LSR) - Body ground
    GR - Body ground
    Rear door LH lock position switch input
    Power switch off, all doors closed and rear door LH locked
    11 to 14 V
    2B-29 (LSR) - Body ground
    GR - Body ground
    Rear door RH lock position switch input
    Rear door RH unlocked
    Below 1 V
    2B-29 (LSR) - Body ground
    GR - Body ground
    Rear door RH lock position switch input
    Power switch off, all doors closed and rear door RH locked
    11 to 14 V
    L7-6 (LRCY) - Body ground
    G - Body ground
    Rear door courtesy light switch input
    Rear door open
    Below 1 V
    L7-6 (LRCY) - Body ground
    G - Body ground
    Rear door courtesy light switch input
    Rear door closed
    11 to 14 V
    L7-7 (LSFL) - Body ground
    GR - Body ground
    Driver door lock position switch input
    Driver door unlocked
    Below 1 V
    L7-7 (LSFL) - Body ground
    GR - Body ground
    Driver door lock position switch input
    Power switch off, all doors closed and driver door locked
    11 to 14 V
    L7-9 (L1) - Body ground
    LG - Body ground
    Front passenger side door control switch input
    Front passenger side door control switch locked
    Below 1 V
    L7-9 (L1) - Body ground
    LG - Body ground
    Front passenger side door control switch input
    Front passenger side door control switch off
    11 to 14 V
    L7-10 (UL1) - Body ground
    BR - Body ground
    Front passenger side door control switch input
    Front passenger side door control switch unlocked
    Below 1 V
    L7-10 (UL1) - Body ground
    BR - Body ground
    Front passenger side door control switch input
    Front passenger side door control switch off
    11 to 14 V
    L7-11 (L2) - Body ground
    G - Body ground
    Driver door key-linked lock input
    Driver door key cylinder turned to lock
    Below 1 V
    L7-11 (L2) - Body ground
    G - Body ground
    Driver door key-linked lock input
    Driver door key cylinder off
    11 to 14 V
    L7-18 (LSFR) - Body ground
    LG - Body ground
    Front passenger side door lock position switch input
    Front passenger side door unlocked
    Below 1 V
    L7-18 (LSFR) - Body ground
    LG - Body ground
    Front passenger side door lock position switch input
    Power switch off, all doors closed and front passenger side door locked
    11 to 14 V
    L7-19 (BCTY) - Body ground
    L - Body ground
    Back door courtesy light switch input
    Back door open
    Below 1 V
    L7-19 (BCTY) - Body ground
    L - Body ground
    Back door courtesy light switch input
    Back door closed
    11 to 14 V
    L7-23 (BDSU) - Body ground*1
    GR - Body ground
    Back door opener switch input
    Back door opener switch pushed
    Below 1 V
    L7-23 (BDSU) - Body ground*1
    GR - Body ground
    Back door opener switch input
    Back door opener switch not pushed
    11 to 14 V
    L7-24 (UL3) - Body ground
    V - Body ground
    Driver door key-linked unlock input
    Driver door key cylinder turned to unlock
    Below 1 V
    L7-24 (UL3) - Body ground
    V - Body ground
    Driver door key-linked unlock input
    Driver door key cylinder off
    11 to 14 V

    1. *1: w/o Entry System Back Door Open Function
    If the result is not as specified, the main body ECU (multiplex network body ECU) may have a malfunction.


CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (w/ Entry System Back Door Open Function)

B203498E14

  1. Disconnect the L62 certification ECU (smart key ECU assembly) connector.

  2. Measure the resistance according to the value(s) in the table below.

    HINT:
    Measure the values on the wire harness side with the connector disconnected.


    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    L62-22 (TSW5) - Body ground
    GR - Body ground
    Back door opener switch signal
    Back door opener switch on
    Below 1 Ω
    L62-22 (TSW5) - Body ground
    GR - Body ground
    Back door opener switch signal
    Back door opener switch off
    10 kΩ or higher
    If the result is not as specified, there may be a malfunction in the wire harness.

  3. Reconnect the L62 certification ECU (smart key ECU assembly) connector.

  4. Measure the voltage according to the value(s) in the table below.

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    L62-22 (TSW5) - Body ground
    GR - Body ground
    Back door opener switch signal
    Back door opener switch off
    11 to 14 V
    L62-22 (TSW5) - Body ground
    GR - Body ground
    Back door opener switch signal
    Back door opener switch on
    Below 1 V
    If the result is not as specified, the certification ECU (smart key ECU assembly) may have a malfunction.