Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ELECTRICAL KEY OSCILLATOR (for Rear Floor)

ELECTRICAL KEY OSCILLATOR (for Rear Floor) > REMOVAL

for Preparation Click here



1. REMOVE REAR NO. 2 FLOOR BOARD (for Separate Type)


    B227787E01
  1. Disengage the 2 guides <A> as shown in the illustration.

  1. Disengage the 3 guides <B> and remove the rear No. 2 floor board.



2. REMOVE REAR DECK FLOOR BOX
  1. Remove the rear deck floor box.



3. REMOVE ELECTRICAL KEY OSCILLATOR


    B229288
  1. Disconnect the connector.

  1. Disengage the clamp and remove the electrical key oscillator.

    NOTICE:
    Be careful when removing the electrical key oscillator. If the oscillator is dropped, replace it with a new one.