Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ELECTRICAL KEY OSCILLATOR (for Center Floor)

ELECTRICAL KEY OSCILLATOR (for Center Floor) > REMOVAL

for Preparation Click here



1. REMOVE REAR SEAT CUSHION ASSEMBLY


    B229992E02
  1. Disengage the 2 front hooks of the seat cushion from the vehicle body as shown in the illustration.
    Text in Illustration 
    *1
    Hook
    *2
    Guide
    *a
    100 mm (3.94 in.) or less

    NOTICE:
    Follow the instructions below carefully as the cushion frame deforms easily.


    1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

    2. Repeat the above procedure for the other hook.

  1. Disengage the 2 guides of the seat cushion from the seatback.

  1. Remove the rear seat cushion assembly.



2. REMOVE ELECTRICAL KEY OSCILLATOR


    B297105
  1. Remove the 2 clips from the floor carpet.



    B297106
  1. Remove the bolt.

  1. Disconnect the connector and remove the electrical key oscillator.

    NOTICE:
    Be careful when removing the electrical key oscillator. If the oscillator is dropped, replace it with a new one.