Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DESCRIPTION
  1. Air conditioning system data and the Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform troubleshooting.


CHECK DLC3
  1. Check the DLC3 (Click here).


LIST OF OPERATION METHODS


  1. By operating each of the air conditioning control switches as shown in the diagram below, it is possible to enter diagnostic check mode.


    E180201E07


INDICATOR CHECK
  1. Turn the power switch off.

  2. Turn the power switch on (ACC) and wait for at least 5 seconds.



  3. E240815E01
  4. Turn the power switch on (IG) while pressing the A/C control assembly "AUTO" switch and "Recirculation/Fresh" switch simultaneously. Hold both switches until the indicator check screen appears.
    Text in Illustration 
    *1
    A/C Control Assembly



  5. E240816E01
  6. The indicator check is automatically performed when panel diagnosis is activated. Check that the indicators light up and go off 4 times at 1-second intervals continuously.

    HINT:
    1. The sensor check automatically starts when the indicator check is completed.
    2. Press the "OFF" switch to cancel the check mode.

    Text in Illustration 
    *1
    A/C Control Assembly


SENSOR CHECK (DTC CHECK)
  1. Start the hybrid system and warm it up.

  2. Perform the indicator check.

    HINT:
    After the indicator check is completed, the system enters DTC check mode automatically.



  3. E240817E01
  4. Read the DTC displayed on the A/C control assembly.

    NOTICE:
    In sensor check mode, which is automatically entered after indicator check mode, troubleshooting may be partially performed. Be sure to perform the sensor check again.

    HINT:
    Refer to Diagnostic Trouble Code Chart for details of the codes (Click here).
    1. When there are no problems, DTC 00 is output.
    2. As an example, the illustration shows that display DTC 12 is output.

    Text in Illustration 
    *1
    A/C Control Assembly
    *2
    Diagnostic Trouble Code (DTC)



  5. E240818E01
  6. If the DTCs are difficult to read because they change automatically, press the "MODE" switch to display the DTCs one at a time so that they can be read easily. The DTCs are displayed step by step each time the "MODE" switch is pressed.

    HINT:
    Press the "OFF" switch to finish panel diagnosis.

    Text in Illustration 
    *1
    A/C Control Assembly



  7. Clear the DTC



      E240819E01
    1. During the sensor check, press the "FRONT DEF" switch and "MODE" switch simultaneously.
      Text in Illustration 
      *1
      A/C Control Assembly