MILLIMETER WAVE RADAR SENSOR > REMOVAL |
| 1. REMOVE RADIATOR SUPPORT OPENING COVER |
![]() |
Remove the 3 clips.
Disengage the 2 claws and remove the radiator support opening cover.
| 2. REMOVE FRONT BUMPER ASSEMBLY |
![]() |
Put protective tape around the front bumper assembly.
| *1 | Protective Tape |
![]() |
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
![]() |
Remove the screw.
w/o Front Spoiler:
![]() |
Using a clip remover, remove the 7 clips.
Remove the 2 bolts.
![]() |
Remove the 4 screws
w/ Front Spoiler:
![]() |
Using a clip remover, remove the clip.
Remove the 6 bolts and 6 screws, and front spoiler cover.
![]() |
Remove the 2 bolts.
Using a clip remover, remove the 7 clips.
![]() |
Disengage the 3 claws and remove the front bumper assembly.
![]() |
Pull back the side of the front bumper assembly as shown in the illustration and disconnect the connector.
w/ Headlight Cleaner System:
![]() |
Disconnect the headlight cleaner hose and drain the washer fluid.
![]() |
Remove the front bumper assembly as shown in the illustration.
| 3. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY |
![]() |
Disconnect the connector.
Remove the 5 bolts and millimeter wave radar sensor assembly.