Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH

WIPER SWITCH > REMOVAL

for Preparation Click here



1. REMOVE LOWER STEERING COLUMN COVER

NOTICE:
Removing the lower steering column cover in the incorrect order will cause the lower steering column cover to break.

  1. Release the tilt and telescopic lever, and fully extend and lower the steering column assembly.

  1. Lock the tilt and telescopic lever.



    E190078
  1. Push the right and left sides of the lower steering column cover to disengage the 4 claws.



    E190077
  1. Insert fingers into the opening of the tilt lever of the lower steering column cover to disengage the claw.

    HINT:
    Spread the claw to disengage it.



    E190956E01
  1. Turn the steering wheel assembly to the right.

  1. Using a screwdriver, disengage the claw as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.



    E190957E01
  1. Turn the steering wheel assembly to the left.

  1. Using a screwdriver, disengage the claw as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.



    E190988
  1. Remove the lower steering column cover as shown in the illustration.



2. REMOVE UPPER STEERING COLUMN COVER


    E190079
  1. Disengage the claw and 2 pins, and remove the upper steering column cover.



3. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


    E189319
  1. Turn the steering wheel assembly to the right.

  1. Disconnect the 2 connectors.

  1. Disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.

    NOTICE:
    If the claw is pushed with excessive force, it may break.