Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER ACTUATOR

HEADLIGHT CLEANER ACTUATOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT BUMPER ASSEMBLY
(Click here)


2. REMOVE HEADLIGHT CLEANER WASHER NOZZLE COVER


    E239907E01
  1. Extend the headlight cleaner washer nozzle cover.
    Text in Illustration 
    *1
    Protective Tape

  1. Using a screwdriver, disengage the 2 claws and remove the headlight cleaner washer nozzle cover.

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure for the RH side and LH side.



3. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH


    E239909E01
  1. Disconnect the headlight cleaner hose.
    Text in Illustration 
    *1
    No. 3 Headlight Cleaner Clamp
    *2
    Headlight Cleaner Hose

  1. Remove the No. 3 headlight cleaner clamp.



    E239911E01
  1. Pull down the No. 1 headlight cleaner clamp.
    Text in Illustration 
    *1
    No. 1 Headlight Cleaner Clamp



    E239913E01
  1. Pushing the tab and disengage the 2 claws and remove the headlight washer actuator sub-assembly LH as shown in the illustration.
    Text in Illustration 
    *1
    Tab



4. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.