HEADLIGHT CLEANER MOTOR > INSTALLATION |
| 1. INSTALL HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY |
![]() |
Install the headlight cleaner motor and pump assembly.
Connect the headlight cleaner hose to the headlight cleaner motor and pump assembly with the clip as shown in the illustration.
Connect the connector.
| 2. INSTALL FRONT BUMPER ASSEMBLY |
w/ Headlight Cleaner System:
Connect the headlight cleaner hose.
Connect the connector.
![]() |
Install the front bumper assembly as shown in the illustration.
![]() |
Engage the 3 claws to install the front bumper assembly.
w/o Front Spoiler:
Install the 4 screws.
Install the 2 bolts.
Install the 7 clips.
w/ Front Spoiler:
Install the 7 clips.
Install the 2 bolts.
Install the front spoiler cover with the 6 bolts and 6 screws.
Install the clip.
Install the screw.
![]() |
Install the pin hold clip.
| *a | Correct |
| *b | Incorrect |
| 3. INSTALL RADIATOR SUPPORT OPENING COVER |
Engage the 2 claws and install the radiator support opening cover.
Install the 3 clips.
| 4. ADD WINDSHIELD WASHER FLUID |
Add washer fluid to the washer jar.
| 5. PREPARE VEHICLE FOR FOG LIGHT AIM ADJUSTMENT (w/ Fog Light) |
Prepare the vehicle:
| 6. PREPARE FOR FOG LIGHT AIMING (w/ Fog Light) |
![]() |
Prepare the vehicle:
Prepare a piece of thick white paper (approximately 2 m (6.56 ft.) (height) x 4 m (13.1 ft.) (width)) to use as a screen.
Draw a vertical line down the center of the screen (V line).
Set the screen as shown in the illustration.

![]() |
Draw base lines (H, V LH, and V RH lines) on the screen as shown in the illustration.
| *a | V LH Line |
| *b | V Line |
| *c | V RH Line |
| *d | H Line |
| *e | Ground |
H Line (Fog light height):
Draw a horizontal line across the screen so that it passes through the center marks. The H line should be at the same height as the fog light bulb center marks of the fog lights.
V LH Line, V RH Line (Center mark position of left-hand (LH) and right-hand (RH) fog lights):
Draw two vertical lines so that they intersect the H line at each center mark (aligned with the center of the fog light bulbs).
| 7. INSPECT FOG LIGHT AIMING (w/ Fog Light) |
Cover the fog light or disconnect the connector of the fog light on the opposite side to prevent light from the fog light that is not being inspected from affecting the fog light aiming inspection.
Start the engine.
Turn on the fog lights and check if the upper edge of the hot zone for each fog light matches the upper edge as shown in the illustration.

| 8. ADJUST FOG LIGHT AIMING (w/ Fog Light) |
![]() |
Adjust the aim vertically:
Adjust the aim of each fog light to the specified range by turning each aiming screw with a screwdriver.
| *1 | Aiming Screw |