HEADLIGHT CLEANER MOTOR > REMOVAL |
| 1. REMOVE RADIATOR SUPPORT OPENING COVER |
![]() |
Remove the 3 clips.
Disengage the 2 claws and remove the radiator support opening cover.
| 2. REMOVE FRONT BUMPER ASSEMBLY |
![]() |
Put protective tape around the front bumper assembly.
| *1 | Protective Tape |
![]() |
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
![]() |
Remove the screw.
w/o Front Spoiler:
![]() |
Using a clip remover, remove the 7 clips.
Remove the 2 bolts.
![]() |
Remove the 4 screws
w/ Front Spoiler:
![]() |
Using a clip remover, remove the clip.
Remove the 6 bolts and 6 screws, and front spoiler cover.
![]() |
Remove the 2 bolts.
Using a clip remover, remove the 7 clips.
![]() |
Disengage the 3 claws and remove the front bumper assembly.
![]() |
Pull back the side of the front bumper assembly as shown in the illustration and disconnect the connector.
w/ Headlight Cleaner System:
![]() |
Disconnect the headlight cleaner hose and drain the washer fluid.
![]() |
Remove the front bumper assembly as shown in the illustration.
| 3. REMOVE HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY |
![]() |
Loosen the clip and disconnect the headlight cleaner hose from the headlight cleaner motor and pump assembly as shown in the illustration.
Disconnect the connector and remove the headlight cleaner motor and pump assembly.