DOOR CONTROL TRANSMITTER > INSPECTION |
| 1. INSPECT ELECTRICAL KEY TRANSMITTER |
Inspect operation of the transmitter.
Remove the battery (lithium battery) from the transmitter (Click here).
![]() |
Install a new or normal battery (lithium battery).
From outside the vehicle, approximately 1 m (3.28 ft.) away from the driver side outside door handle, test the transmitter by pointing its key plate at the vehicle and pressing a transmitter switch.
Inspect the battery capacity.
Remove the battery (Click here) from the electrical key transmitter that does not operate. Attach a lead wire (0.6 mm (0.0236 in.) in diameter or less including wire sheath) with tape or equivalent to the negative terminal.
![]() |
Carefully pull the lead wire out from the position shown in the illustration and install the previously removed transmitter battery.
![]() |
Using an oscilloscope, check the transmitter battery voltage waveform.
| Item | Content |
| Tester Connection | Battery positive (+) - Battery negative (-) |
| Tool Setting | 0.5 V/DIV., 100 ms/DIV. |
| Condition | Power switch OFF, all doors closed and lock sensor touched |
| Specified Condition | 2.2 to 3.2 V (Refer to the waveform) |