Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK

REAR DOOR LOCK > INSPECTION

for Preparation Click here



1. INSPECT REAR DOOR LOCK ASSEMBLY LH


    B228541E01
  1. Check the operation of the door lock motor.

    1. Apply battery voltage and check the operation of the door lock motor.

      OK:
      Connection
      Result
      Battery positive (+) → Terminal 4 (L)
      Battery negative (-) → Terminal 1 (UL)
      Locks
      Battery positive (+) → Terminal 1 (UL)
      Battery negative (-) → Terminal 4 (L)
      Unlocks

      Text in Illustration 
      *1
      Component without harness connected
      (Rear Door Lock Assembly LH)
      *2
      Lock
      *3
      Unlock
      If the result is not as specified, replace the rear door lock assembly LH.



    B228541E02
  1. Check the operation of the unlock detection switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      6 (LSSR) - 9 (E)
      Locked
      10 kΩ or higher
      6 (LSSR) - 9 (E)
      Unlocked
      Below 1 Ω

      Text in Illustration 
      *1
      Component without harness connected
      (Rear Door Lock Assembly LH)
      *2
      Lock
      *3
      Unlock
      If the result is not as specified, replace the rear door lock assembly LH.



2. INSPECT REAR DOOR LOCK ASSEMBLY RH


    B228542E01
  1. Check the operation of the door lock motor.

    1. Apply battery voltage and check the operation of the door lock motor.

      OK:
      Connection
      Result
      Battery positive (+) → Terminal 4 (L)
      Battery negative (-) → Terminal 1 (UL)
      Locks
      Battery positive (+) → Terminal 1 (UL)
      Battery negative (-) → Terminal 4 (L)
      Unlocks

      Text in Illustration 
      *1
      Component without harness connected
      (Rear Door Lock Assembly RH)
      *2
      Unlock
      *3
      Lock
      If the result is not as specified, replace the rear door lock assembly RH.



    B228542E02
  1. Check the operation of the unlock detection switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      6 (LSSR) - 9 (E)
      Locked
      10 kΩ or higher
      6 (LSSR) - 9 (E)
      Unlocked
      Below 1 Ω

      Text in Illustration 
      *1
      Component without harness connected
      (Rear Door Lock Assembly RH)
      *2
      Unlock
      *3
      Lock
      If the result is not as specified, replace the rear door lock assembly RH.