Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > INSTALLATION

for Preparation Click here



1. INSTALL OUTER MIRROR COVER


    B221547
  1. Engage the 8 claws to install the outer mirror cover.

    NOTICE:
    Securely engage the 8 claws.



2. INSTALL OUTER MIRROR


  1. w/o Mirror Heater:



      B221554
    1. Engage the 2 guides on the upper part of the outer mirror to the outer rear view mirror.



  1. w/ Mirror Heater:



      B221541
    1. Connect the 2 connectors.

    2. Engage the 2 guides on the upper part of the outer mirror to the outer rear view mirror.



    B221542
  1. Engage the 2 claws on the lower part of the outer mirror to the outer rear view mirror as shown in the illustration.



    B221531
  1. Push the outside part of the outer mirror assembly and tilt it as shown in the illustration.



3. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY


    B221538
  1. Engage the clip to install the outer rear view mirror assembly.

  1. Install the outer rear view mirror assembly with the 3 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the connector.



4. INSTALL OUTER MIRROR INSTALL HOLE COVER


    B221537
  1. Engage the guide and 2 claws to install the outer mirror install hole cover.



5. INSTALL OUTER MIRROR PROTECTOR


    B221534
  1. Engage the 2 claws.

  1. Install the outer mirror protector with the screw.



6. INSTALL FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY


    B228676
  1. Connect the front door lock remote control cable assembly and front door inside locking cable assembly to the front door inside handle.



    B228673
  1. Engage the 2 claws and install the front door inside handle sub-assembly to the front door trim board sub-assembly.



7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B228671
  1. Engage the 9 clips and install the front door trim board sub-assembly.

  1. Install the 2 screws.

  1. Remove the 2 pieces of protective tape.



8. INSTALL COURTESY LIGHT ASSEMBLY
  1. Connect the connector.



    E189696E01
  1. Engage the claw to install the courtesy light assembly.



9. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)


    B228663
  1. Connect the connector.

  1. Engage the 7 claws and 3 guides, and install the power window regulator master switch assembly with front door armrest base panel.



10. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
  1. Connect each connector.



    B232008
  1. Engage the 7 claws and 3 guides, and install the power window regulator switch assembly with front door armrest base panel.



11. INSTALL DOOR ARMREST COVER


    B228665
  1. Install the door armrest cover.



12. INSTALL ASSIST GRIP COVER


    B228660
  1. Engage the 6 claws, 2 clips and 3 guides, and install the assist grip cover.



13. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG


    B228657
  1. Engage the 3 claws and install the front door inside handle bezel plug.