Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › WATER PUMP WITH MOTOR

WATER PUMP WITH MOTOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT SPOILER COVER (w/ Front Spoiler)


2. REMOVE ENGINE UNDER COVER (w/ Cover)


3. REMOVE NO. 1 ENGINE UNDER COVER


4. DRAIN COOLANT (for Inverter)

NOTICE:
  1. Do not reuse the drained coolant because it may contain foreign matter.
  2. Collect the drained coolant and measure its volume to establish a benchmark. When adding coolant, make sure to add more coolant than the measured amount.

  1. Remove the reserve tank cap.

    CAUTION:
    To avoid the danger of being burned, do not remove the reserve tank cap while the coolant for the inverter is still hot.



    A214669
  1. Using a hexagon wrench (10 mm), remove the drain plug indicated in the illustration and drain the coolant.

    CAUTION:
    Use caution when handling coolant immediately after driving or in summer because it may be hot.

  1. Install the plug with a new gasket.

    Torque:
    39 N*m{ 397 kgf*cm , 29 ft.*lbf }



5. REMOVE INVERTER WITH CONVERTER ASSEMBLY

HINT:
Click here.



6. REMOVE INVERTER RESERVE TANK ASSEMBLY


    A213024
  1. Remove the 2 bolts and inverter reserve tank assembly.



7. REMOVE INVERTER TRAY BRACKET


    A213025
  1. Separate the 2 clamps.

  1. Remove the 5 bolts and inverter tray bracket.



8. REMOVE INVERTER WATER PUMP ASSEMBLY


    A248081
  1. Disconnect the 2 water hoses and connector.

    NOTICE:
    1. Put pieces of cloth into the pipes and in the disconnected hoses to prevent foreign matter from entering the inverter water pump and cooling system.
    2. Apply insulating tape to the connectors of the wire harness and inverter water pump assembly with motor to prevent the entry of coolant.



    A248082
  1. Remove the 3 bolts, inverter water pump assembly and water pump bracket.