EMISSION CONTROL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK FUEL CUT RPM |
Put the engine in inspection mode (Click here).
Start and warm up the engine.
Increase the engine speed to at least 2500 rpm.
![]() |
Use a sound scope to check for injector operating sounds.
| *1 | Injector |
| *2 | Sound Scope |
When the accelerator pedal is released, check that injector operating sounds stop momentarily (at 2500 rpm or higher) and then resume (at 1200 rpm).
| Item | Specified Condition |
| Fuel cut off rpm | 2500 rpm |
| Fuel injection restart rpm | 1200 rpm |
| 2. VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS |
![]() |
Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.
| 3. INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM |
Connect the Techstream to the DLC3.
![]() |
Disconnect the fuel vapor feed hose from the purge valve shown in the illustration.
Put the engine in inspection mode (Click here).
Start the engine.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for Evap Control.
Check that vacuum occurs at the purge valve port.
If vacuum does not occur, check the following items.
Exit Active Test mode and reconnect the fuel vapor feed hose.
Enter the following menus: Powertrain / Engine and ECT / Data List / EVAP Purge VSV.
Warm up the engine and drive the vehicle.
Confirm that the purge valve opens.
If the result is not as specified, replace the purge valve, wire harness or ECM.
| 4. CHECK FUEL TANK AND VENT LINE |
Disconnect the vent line hose from the canister.
Connect the pressure gauge to the vent line hose.

| *1 | Fuel Tank Cap | *2 | Vent Line Hose |
| *3 | Pressure Gauge | - | - |
Apply 4 kPa (0.04 kgf/cm2, 0.6 psi) of pressure to the vent line of the fuel tank.
Check that the fuel tank pressure is maintained for some time, and does not decrease immediately.
When the fuel tank cap is removed, check that the pressure is released smoothly.
Reconnect the vent line hose to the canister.
| 5. INSPECT AIR INLET LINE |
![]() |
Disconnect the air inlet line hose from the charcoal canister.
| *1 | Air |
Check that air flows freely into the air inlet line.
If air does not flow freely into the air inlet line, repair or replace the air inlet line hose.
Reconnect the air inlet line hose to the charcoal canister.