Home › Engine / Hybrid System › 2ZR-FXE EMISSION CONTROL › PURGE VALVE

PURGE VALVE > INSPECTION

for Preparation Click here



1. INSPECT VACUUM SWITCHING VALVE ASSEMBLY


    A219374
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    23 to 26 Ω

    If the result is not as specified, replace the vacuum switching valve assembly.



  1. Check operation of the vacuum switching valve assembly.



      A219375E01
    1. Blow air into port E. Check that air does not come out of port F.
      Text in Illustration 
      *1
      Port F
      *2
      Port E
      *3
      Air Blow



    2. A219376E01
    3. Apply battery voltage across the terminals.
      Text in Illustration 
      *1
      Port F
      *2
      Port E
      *3
      Air Blow

    4. Blow air into port E. Check that air comes out from port F.
      If the result is not as specified, replace the vacuum switching valve assembly.